. If you have any questions, please let us know.

I see that this snde is compatible with my Microdos MPH P1 doser, but its length (15cm) seems much too long to me! the probe that I have, compatible with Microdos, has a total length of 11.5 cm and the "glass" part of 8.5 cm!

Hello, yes it is possible that your current probe is shorter but it works

And how since if I put it in the place of the other, it will go lower than the pipe?

Can you send me a photo of where the probe is installed?

a moment . . . 2 to 3 mins please

OK

Sorry, I have a connection from m.de and it's taking a long time!

No problem. By SMS if you want 06 80 01 27 53

Ok, you just need to install it like this:

the probe holder allows you to do as you wish? how to slide the probe into the probe holder and make it stop moving?

as you say . . .

If you loosen your probe holder will you get the probe out?

Please, is this a question?

Yes

I don't understand

Sorry, if you loosen your probe holder. Can you get the probe out?

I tried to remove it yesterday to measure the glass part but it revolves around the probe; it is therefore not screwed on and I hesitated to pull hard to remove it for fear of breaking everything!

but i guess it's possible

Normally, yes it is like that! But it may be broken

Effectively !

Do you sell probe holders + "plugs" instead of the probe to plug the pipe and prevent water from coming out and flowing everywhere?

Yes . https://ph-redox-pool.com/gb/probe-holder-and-support-collar/1637-12-ph-orp-probe-holder.html

https://ph-redox-pool.com/gb/probe-holder-and-support-collar/1638-12-ph-orp-probe-holder.html

For the cap you can also use an old probe!

It's all very clear! THANKS ! one last point, the diameter of the probe is standard?

Yes, it's 12mm

I imagine this probe is of good quality and its lifespan is approximately how long?

82% exceed 3 years

OK, all I have to do now is do my shopping! Good day to you !

You are welcome, do not hesitate to contact us! Good day