Replacement Guide for EMEC Model SCL 18/2 Probe If you need to replace the EMEC Model SCL 18/2 Probe, please follow the steps below: 1. Ensure that the power supply to the EMEC system is turned off. 2. Disconnect the probe from the EMEC system by carefully removing the electrical connections. 3. Unscrew the probe from its mounting position using an appropriate tool. 4. Take the new EMEC Model SCL 18/2 Probe and screw it into the same mounting position. Make sure it is securely tightened. 5. Reconnect the electrical connections, ensuring that they are properly aligned and securely fastened. 6. Turn on the power supply to the EMEC system and check for proper functionality. Please note that it is important to handle the probe with care and follow the manufacturer's instructions for installation and usage.